【转】warp解锁奈飞，后台监控自动刷新ip 脚本

a8866051

重启服务器后需要重新配置吗？还是说可以做一个开机自启脚本？

rru

Failed to restart [email protected]: Unit [email protected] not found.

micms

技术大佬 mark

Christos

顶。。

Christos

12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 systemd[1]: Starting WireGuard via wg-quick(8) for wgcf...
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: [#] ip link add wgcf type wireguard
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: [#] wg setconf wgcf /dev/fd/63
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: [#] ip -4 address add 172.16.0.2/32 dev wgcf
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: [#] ip -6 address add fd01:5ca1:ab1e:8d0d:abe5:44f6:a7a9:387/128 dev wgcf
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: [#] ip link set mtu 1420 up dev wgcf
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: [#] mount `8.8.8.8 8.8.4.4 2001:4860:4860::8888 2001:4860:4860::8844' /etc/resolv.conf
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: [#] wg set wgcf fwmark 51820
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: [#] ip -4 route add 0.0.0.0/0 dev wgcf table 51820
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: [#] ip -4 rule add not fwmark 51820 table 51820
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: [#] ip -4 rule add table main suppress_prefixlength 0
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: [#] sysctl -q net.ipv4.conf.all.src_valid_mark=1
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: [#] iptables-restore -n
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: /usr/bin/wg-quick: line 32: iptables-restore: command not found
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: [#] umount /etc/resolv.conf
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: [#] ip -4 rule delete table 51820
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: [#] ip -4 rule delete table main suppress_prefixlength 0
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 wg-quick[98369]: [#] ip link delete dev wgcf
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 systemd[1]: [email protected]: Main process exited, code=exited, status=127/n/a
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 systemd[1]: [email protected]: Failed with result 'exit-code'.
12月 11 14:57:52 centos-s-1vcpu-1gb-intel-sgp1-01 systemd[1]: Failed to start WireGuard via wg-quick(8) for wgcf.
报错啊

rqk666

Dec 14 18:08:58 NoxiousLeft-VM systemd[1]: [email protected]: Failed with result 'exit-code'.
Dec 14 18:08:58 NoxiousLeft-VM systemd[1]: Failed to start WireGuard via wg-quick(8) for wgcf.
Dec 14 18:15:27 NoxiousLeft-VM systemd[1]: Starting WireGuard via wg-quick(8) for wgcf...
Dec 14 18:15:27 NoxiousLeft-VM wg-quick[1317]: [#] ip link add wgcf type wireguard
Dec 14 18:15:27 NoxiousLeft-VM wg-quick[1317]: Error: Unknown device type.
Dec 14 18:15:27 NoxiousLeft-VM wg-quick[1317]: Unable to access interface: Protocol not supported
Dec 14 18:15:27 NoxiousLeft-VM wg-quick[1317]: [#] ip link delete dev wgcf
Dec 14 18:15:27 NoxiousLeft-VM wg-quick[1317]: Cannot find device "wgcf"

我也报错了

mazilong

好帖

pqpq

请教这一步怎么设置?还有用楼主的这个脚本,一直刷Ip 无论是美区还是港区我都还没成功过,另外一个warp一键脚本反而一次成功...

设置：每隔多长时间检测一下ip的解锁是否有效
脚本36行            echo -e "Region: ${region} Done, monitoring..."
脚本37行            sleep 6
第37行的sleep 6可以改成任意时间，单位是秒，一般来说，1分钟即sleep 60就行，ip基本都可以存活一整天以上，不需要那么频繁的检测

charles97

谢谢楼主，请教一下，不看奈飞的时候要不要停止warp？还有怎么看warp用的流量。谢谢

虚竹

越来越难扫到，而且容易两三天就崩了